Adjustable Treat Dispenser Toy for Dogs & Cats

Treat Time You Can Make Easier or Harder

I designed this treat dispenser so one toy can fit your pet as they learn. Fill it with kibble, set it down, and let your dog or cat push and roll it to get the treats out through the openings at each end. Screw in a bushing to make the opening smaller and treat time slower, or take them out to make it faster. Treat time lasts longer, and mealtimes are less boring.

Available in 7 colors: red, green, black, yellow, blue, white and orange.

How It Works

1. Unscrew: Twist the two halves apart.
2. Fill: Add dry kibble or small treats, then screw the halves back together.
3. Choose your opening: With no bushings, the opening is the largest. Screw a medium bushing into an end for a smaller opening, or a small bushing for the smallest.
4. Tighten: Use the included key to tighten the bushings so they stay in place.
5. Play: Set it down and let your pet push and roll it. Kibble works its way along the inside spiral and comes out at the ends.

What Makes It Different

• 🎚️ Adjustable difficulty: Three opening sizes on each end: large (no bushing), medium, and small. Make it easier or harder as your pet gets better at it.
• 🌀 Spiral inside: A helix channel meters the kibble out slowly. Push from one side and kibble comes out, push from the other and it moves back toward the center.
• 🔑 Key included: A custom key installs and removes the bushings, and tightens them so your pet can't easily twist them out.
• 🏃 Gets pets moving: Every push and roll adds movement to snack time and keeps them busy for longer.
• 🧼 Easy to refill and clean: It unscrews into two halves.

Choose Your Size

Pick the opening by your pet's kibble size. As a guide, kibble comes out freely through an opening about 1.3 to 1.5 times its width. Most cat kibble is 7 to 9 mm, medium dog kibble is 11 to 14 mm, and large dog kibble is 15 to 17 mm. Treat size and shape change how quickly pieces come out, and some pets figure it out faster than others. If your pet is new to treat toys, show them how it works and reward them as they learn.

What's in the Box

• 1 treat dispenser (two halves)
• 2 small bushings
• 2 medium bushings
• 1 key to install and remove the bushings

Keep the key and loose bushings away from pets and children.

Designed in Vancouver

I'm Ray, the designer and founder of Petsun. I design every toy myself and make it in Vancouver, BC. It is made from PLA, a plant-based bioplastic.

Care and Cleaning

• Take it apart, rinse and dry after use.
• Hand wash only, in lukewarm water. Very hot water can deform PLA.
• For indoor use.
• Use with supervision, and take the toy away if it gets damaged.

Specifications